Box for seed packets
Glued corner tray
- Sized for
- 20 × Seed packet (standard, US)
- Product
- 114.3 × 82.6 mm, ×20 (estimate)
- Inside
- 118 × 87 × 34 mm
- Board
- SBS / GC1 board 350 gsm (0.45 mm)
- Blank
- 187 × 156 mm
Make this box About the glued corner tray
Folded shut and measured in 3D: the cavity is 118 × 87 × 33.3 mm and the product block fits without touching the board. Free to open and change; €2.50 for the PDF, €3.50 for the DXF or SVG.
Why these numbers
Twenty packets flat in a tray, the seed-swap box. Add a sleeve to close it.
Every size on this page is an example to start from. Products change between models, editions and makers, so measure the one you are packing.
Where the product size comes from
Seed packets: from a packaging or retail supplier's listing.
“3.25" W x 4.5" H”
qualitylogoproducts.com
The flat blank
- Four corner tray: the walls fold up, the corner tabs swing round and glue to the inside of the long walls.
- The corner tab sits 0.45 mm inside the wall - exactly one caliper - and starts 0.45 mm above the floor so it clears the base board.
- The short walls are inset by 0.45 mm at both ends so they stand inside the long walls.
- This construction needs glue. Pick a slotted tray if there is no gluer available.
More boxes like this
Product and brand names are used only to say what the box is sized for. They belong to their owners; CardboardShaper is not affiliated with or endorsed by any of them.