Sleeve for a soap bar
Sleeve · ECMA A01.01.00.00
- Sized for
- standard bar of soap 4 oz (common soap mold cavity)
- Product
- 76.2 × 50.8 × 34.9 mm
- Inside
- 78 × 53 × 37 mm
- Board
- Kraft / GD2 board 400 gsm (0.50 mm)
- Blank
- 278 × 37 mm
Make this box About the sleeve
Folded shut and measured in 3D: the cavity is 78 × 53 × 36 mm and the product block fits without touching the board. Free to open and change; €2.50 for the PDF, €3.50 for the DXF or SVG.
Why these numbers
A 4 oz bar (76 × 51 × 35 mm, the common mold) in a kraft sleeve, the cheapest soap packaging that still carries a label.
Every size on this page is an example to start from. Products change between models, editions and makers, so measure the one you are packing.
Where the product size comes from
Sleeve for a soap bar: from a packaging or retail supplier's listing.
“Cavity Dimensions: "2" X 3" X 1 3/8""; Capacity per cavity: "4.9 oz"”
bulkapothecary.com
The flat blank
- Sleeve: four faces around a glued seam, open top and bottom. Slides over a tray, a drawer or the bare product.
- Each face scores at internal + 0.5 mm, because half a caliper disappears into every corner.
- The depth (37 mm) needs no compensation: nothing folds inward at the ends.
- Glue flap 14 mm, trimmed 0.5 mm at both ends so the seam does not bulge.
More boxes like this
Product and brand names are used only to say what the box is sized for. They belong to their owners; CardboardShaper is not affiliated with or endorsed by any of them.