Box for a hot dog
Takeaway box with hinged lid
- Sized for
- hot dog bun
- Product
- 152.4 × 50.8 × 44.5 mm
- Inside
- 172 × 71 × 60 mm
- Board
- Kraft / GD2 board 400 gsm (0.50 mm)
- Blank
- 293 × 295 mm
Make this box About the takeaway box with hinged lid
Folded shut and measured in 3D: the cavity is 172 × 71 × 60 mm and the product block fits without touching the board. Free to open and change; €2.50 for the PDF, €3.50 for the DXF or SVG.
Why these numbers
A 6-inch split-top bun (152 × 51 × 45 mm). 10 mm each side and 15 mm above for the sausage end and the toppings.
Food. If the food touches the board, ask your board supplier for food-contact grade board. The drawing sets the shape; it does not make the board food-safe.
Every size on this page is an example to start from. Products change between models, editions and makers, so measure the one you are packing.
Where the product size comes from
A hot dog: from the manufacturer's published specification.
“Length: 6 Inches, Height: 1.75 Inches, Width: 2 Inches”
klostermanbakery.com
The flat blank
- Takeaway box: a glued corner tray with a lid hinged on its back wall. The lid closes down over the outside of the base.
- The back wall is 60.5 mm, one board higher than the inside height plus half a board, so the lid lies flat on the wall tops.
- The lid side walls stand 0.1 mm clear of the base; at the front the lid is one board wider (1.1 mm) because its corner tabs sit between the two front walls.
- The lid reaches 30 mm down the base walls. It holds by friction; a sticker on the front keeps it shut in transport.
- All six corner tabs need glue.
More boxes like this
Product and brand names are used only to say what the box is sized for. They belong to their owners; CardboardShaper is not affiliated with or endorsed by any of them.