Box for MiniDiscs
Reverse tuck carton · ECMA A20.20.03.01
- Sized for
- 5 × MiniDisc in cartridge/case
- Product
- 72 × 68 × 5 mm, ×5
- Inside
- 70 × 27 × 74 mm
- Board
- SBS / GC1 board 350 gsm (0.45 mm)
- Blank
- 210 × 167 mm
Make this box About the reverse tuck carton
Folded shut and measured in 3D: the cavity is 74.8 × 69.5 × 27 mm and the product block fits without touching the board. Free to open and change; €2.50 for the PDF, €3.50 for the DXF or SVG.
Why these numbers
Five MiniDiscs in their cartridges (72 × 68 × 5 mm), stacked.
Every size on this page is an example to start from. Products change between models, editions and makers, so measure the one you are packing.
Where the product size comes from
MiniDiscs: from a published standard or format specification.
“68×72×5 mm”
en.wikipedia.org
The flat blank
- Reverse tuck (ECMA A20.20.03.01): the top closes from the back, the bottom from the front. Nests more economically on the sheet.
- The tuck flap is 0.60 mm narrower on each side than the closing panel - a full caliper plus clearance - so it slides past the side walls and the glue seam.
- Closing order: dust flaps in, closing panel over them, tuck flap behind the wall.
More boxes like this
Product and brand names are used only to say what the box is sized for. They belong to their owners; CardboardShaper is not affiliated with or endorsed by any of them.