Box for 10-inch records
Mailer box · FEFCO 0427
- Sized for
- 3 × 10-inch vinyl record in its jacket
- Product
- 267 × 267 × 2.5 mm, ×3 (estimate)
- Inside
- 273 × 273 × 14 mm
- Board
- B-flute corrugated (3.0 mm)
- Blank
- 513 × 606 mm
Make this box About the mailer box
Folded shut and measured in 3D: the cavity is 273 × 273 × 14 mm and the product block fits without touching the board. Free to open and change; €2.50 for the PDF, €3.50 for the DXF or SVG.
Why these numbers
The forgotten format: 10-inch jackets fall between LP and single mailers. Three records, B-flute like the LP box, because 267 mm of flat jacket bends easily.
Every size on this page is an example to start from. Products change between models, editions and makers, so measure the one you are packing.
Where the product size comes from
10-inch records: from a packaging or retail supplier's listing.
“10" Record | 10.5 x 10.5 | 267 x 267 | 26.7 x 26.7”
musicrecordshop.com
The flat blank
- Folding order: 1) front and back wall up. 2) dust flaps in. 3) side wall up, over the roll bridge, inner wall down. 4) push the tongues at the foot of the inner wall straight into the slots in the base. 5) close the lid and drop the ears into the side pockets.
- Roll bridge = 9.80 mm: 2 layer(s) of 3 mm plus 0.80 mm clearance.
- Front and back wall are inset 6.00 mm at both ends so they fall inside the ear plane. Without that set-back the lid ear runs straight into the front wall.
- The inner wall ends in 2 tongues per side that go straight into slots in the base - no folded-over tab, so the roll has no reverse crease and the sheet never needs turning.
More boxes like this
Product and brand names are used only to say what the box is sized for. They belong to their owners; CardboardShaper is not affiliated with or endorsed by any of them.